(£82.80 Inc. VAT) |
Product code: FL-SLV-TPM-01 |

|
TPM (Tripropylene glycol monomethyl ether) is an alternative to IPA, used to dissolve uncured resin on SLA 3D printed parts.
TPM is a non-flammable low odour solvent with a lower evaporation rate than IPA and can wash up to three times as many parts as IPA before needing to be replaced.
Formlabs generally recommends using IPA (isopropyl alcohol) with a concentration of at least 90% to wash printed parts. If you are unable to use IPA, TPM is a Formlabs tested alternative.
TPM is compatible for use with Formlabs Form Wash, Finish Kit and Cure Stations. TPM is not certified for use with Formlabs biocompatible resins.
Each container holds 5 litres of TPM.